Specifications

• CCD: Sony ICX825AQ ExView2 monochrome CCD
• Pixel count: 1392(H) x 1040(V)
• Pixel size: 6.45 x 6.45uM
• Optical size: 8.98 x 6.71 mm
• Read noise: Typically 5.0 electrons
• QE: Peak QE 75% (yellow light)
• Gain: 0.3 e/ADU
• Barrel size: 31.75mm dia. x 85mm long (1.25 inch eyepiece push fit size)
• Barrel thread: 25.4mm x 0.75mm ‘CS’ mount lens thread
• Input connection: ‘Mini B’ USB socket for USB2.0
• Output connection: Standard RJ12 autoguider socket
• Output type: Opto-isolated 4 lines (N,S,E & W) pull down with common return line
• Download rate: Approx. 2 frames per second in binned 1×1 mode

The Lodestar utilises a very sensitive Sony ‘ExView’ CCD (the ICX829AK) with an array of 752 x 580 pixels in a ‘half-inch’ format. Although the chip is not cooled, it has a very low dark signal and very little readout noise, so it can be used to guide on faint stars that are beyond the reach of webcams and CMOS chip based guide cameras.

Specification

• • CCD type: ICX829AK Sony Exview interline CCD with low dark current and vertical anti-blooming.
  • CCD Full resolution Pixel data: Pixel size: 8.6uM x 8.3uM, Image format: 752 x 580 pixels
  • CCD Image area: 6.4mm (Horizontal) x 4.75mm (Vertical).
  • Colour filter grid array: YMCG secondary colour filters.
  • CCD quality: Grade 1
  • Spectral Response: QE max at 620nM (~65%), 35% at 400nM and 770nM.
  • Readout Noise: Less than 15 electrons RMS – typically only 10 electrons.
  • Full-well capacity: Greater than 50,000 e- (unbinned)
  • Anti-blooming: Overload margin greater than 1000x.
  • Dark current: Dark frame saturation time greater than 1 hour. Less than 0.1 electrons/second @ + 10C ambient.
  • Data format: 16 bits.
  • System gain: 0.9 electrons per ADU
  • Computer Interface: Built-in USB 2.0 compatible interface.
  • Image download time: Typically 0.2 seconds at full resolution using USB 2.0.
  • Power requirements: USB powered.
  • Cooling system: Ambient air cooling.
  • Size: 32 x 72mm black anodised aluminium barrel with 25 x 0.75mm ‘C mount’ thread at the CCD window end & input/output plugs at rear.
  • Weight: approx. 50g.

  Here is a rear view of the guider:

There's lots of advantages of using a CCD chip for deep-sky imaging compared to CMOS cameras.

Please note this camera uses a "Grade 1" CCD chip.

Specifications

• CCD type: Sony ICX825AQ EXview II HAD CCD with ultra low dark current, extended IR response and vertical anti-blooming.
• CCD quality: Grade 1 or better – No bad columns, no dead pixels, no more than 6 ‘hot’ pixels (saturated in <10 seconds).
• CCD Full resolution Pixel data: Pixel size: 6.45uM x 6.45uM, Image format: 1392 x 1040 pixels
• CCD Image area: 8.98mm (Horizontal) x 6.7mm (Vertical).
• Spectral Response: QE max at 540nM (~65%), 50% roll-off at 400nM and 750nM.
• Readout Noise: Typically ONLY 3.5 electrons.
• Full-well capacity: Greater than 23,000 e- (unbinned)
• Anti-blooming: Overload margin greater than 800x.
• Dark current: Dark frame saturation time greater than 100 hours. Less than 0.002 electrons/second @ -10C.
• Data format: 16 bits.
• System gain: 0.3 electrons per ADU
• Computer Interface: Built-in USB 2.0 compatible interface with 3 port USB 2 hub for peripheral devices.
• Image download time: Typically 0.6 seconds full resolution using USB 2.0, approximately 2 seconds with USB 1.1.
• Power requirements: 115VAC / 240VAC @ 12VA, or 12VDC @ 1.5 A max.
• Cooling system: Regulated set-point cooling supply with two stage thermoelectric cooler to give a CCD temperature of better than -40C below ambient. Dry Argon fill.
• Size: 75 x 70mm black anodised aluminium barrel with 42mm ‘T2’ thread at the CCD window end & input/output plugs at rear.
• Weight: approx. 450g

PRODUCT MANUAL Trius-PRO-825C-handbook

PRODUCT DATASHEET 2022-SX-TRIUS-PRO-Blue-Camera-Specification

Specifications:

• CCD type: ICX814AQ (colour) Exview CCD with ultra low dark current and vertical anti-blooming.
• CCD Full resolution pixel data: Pixel size: 3.69uM x 3.69uM, Image format: 3388 x 2712 pixels
• CCD Image area: 12.49mm (Horizontal) x 9.99mm (Vertical).
• CCD quality: Grade 1 or better – No bad columns, no dead pixels, no more than 50 ‘hot’ pixels (saturated in <10 seconds).
• Spectral Response: QE max at 580nM (~77%), 50% roll-off at 360nM and 770nM.
• Readout Noise: Typically only 3 electrons RMS.
• Well depth – 15,000e
• System gain – 0.25e / ADU
• Image download time – 5 seconds in 1 x 1 binning mode
• Anti-blooming: Overload margin greater than 800x.
• Dark current: Less than 0.002 electrons/second @ – 10C CCD temperature.
• Data format: 16 bits.
• System gain: 0.25 electrons per ADU
• Computer Interface: Built-in USB 2.0 compatible interface.
• Power requirements: 115VAC / 240VAC @ 12VA, or 12VDC @ 900mA max.
• Cooling system: Regulated set-point cooling supply with thermoelectric cooler to give a minimum CCD temperature of approximately -40C below ambient.
• Size: 75 x 70mm black anodised aluminium barrel with 42mm ‘T2’ thread at the CCD window end & input/output plugs at rear. CCD alignment screws are provided for setting the chip parallel to the focal plane.
• Weight: approx. 450g

There's lots of advantages of using a CCD chip for deep-sky imaging compared to CMOS cameras.

Please note this camera uses a "Grade 1" CCD chip.

Specifications

• CCD type: ICX694AQ (colour) Exview CCD with ultra low dark current and vertical anti-blooming.
• CCD Full resolution pixel data: Pixel size: 4.54uM x 4.54uM, Image format: 2750 x 2200 pixels
• CCD Image area: 12.49mm (Horizontal) x 9.99mm (Vertical).
• CCD quality: Grade 1 or better – No bad columns, no dead pixels, no more than 50 ‘hot’ pixels (saturated in <10 seconds).
• Spectral Response: QE max at 580nM (~77%), 50% roll-off at 360nM and 770nM.
• Readout Noise: Typically only 3. 5 electrons RMS
• Full-well capacity: Greater than 17,000 e- (unbinned)
• Anti-blooming: Overload margin greater than 800x.
• Dark current: Less than 0.002 electrons/second @ – 10C CCD temperature.
• Data format: 16 bits.
• System gain: 0.3 electrons per ADU
• Computer Interface: Built-in USB 2.0 compatible interface.
• Image download time: Typically 5 seconds at full resolution.
• Power requirements: 115VAC / 240VAC @ 12VA, or 12VDC @ 900mA max.
• Cooling system: Regulated set-point cooling supply with thermoelectric cooler to give a minimum CCD temperature of approximately -40C below ambient.
• Size: 75 x 70mm black anodised aluminium barrel with 42mm ‘T2’ thread at the CCD window end & input/output plugs at rear. CCD alignment screws are provided for setting the chip parallel to the focal plane.
• Weight: approx. 450g

• High speed USB 2.0 interface for approx. 5 second downloads.
• Built-in triple powered USB hub for guider and filter wheel control.
• Single USB cable control for all features – get rid of that dangerous cable tangle!
• Very low power consumption. Less than 1.5 amps at 12v DC.
• Compact and lightweight – only 75mm in diameter x 70mm long – less than 500 grams load on the telescope.

PRODUCT MANUAL Trius-PRO-694C-handbook

PRODUCT DATASHEET 2022-SX-TRIUS-PRO-Blue-Camera-Specification

There's lots of advantages of using a CCD chip for deep-sky imaging compared to CMOS cameras.

Please note this camera uses a "Grade 1" CCD chip.

Specifications

• Built-in autoguider output – compatible with most mounts.
• Built-in triple USB hub ports for accessory control – directly drive filter wheels, GOTO ‘scopes etc.
• Single USB cable control for all features – get rid of that dangerous cable tangle!
• Two stage cooler with dry Argon filled CCD chamber.
• Very low power consumption. Less than 1.5 amps at 12v DC.
• Compact and lightweight – only 75mm in diameter x 70mm long – less than 500 grams load on the telescope.

• CCD type: Sony ICX674ALQ (colour) EXview CCD with ultra low dark current and vertical anti-blooming.
• CCD Full resolution pixel data: Pixel size: 4.54uM x 4.54uM, Image format: 1940 x 1460 pixels
• CCD Image area: 8.81mm (Horizontal) x 6.63mm (Vertical).
• CCD quality: Grade 1 or better – No bad columns, no dead pixels, no more than 50 ‘hot’ pixels (saturated in <10 seconds).
• Spectral Response: QE max at 580nM (~77%), 50% roll-off at 360nM and 770nM.
• Readout Noise: Typically only 3.5 electrons RMS
• Full-well capacity: Greater than 17,000 e- (unbinned)
• Anti-blooming: Overload margin greater than 800x.
• Dark current: Less than 0.003 electrons/second @ – 10C CCD temperature.
• Data format: 16 bits.
• System gain: 0.3 electrons per ADU
• Computer Interface: Built-in USB 2.0 compatible interface.
• Image download time: Typically 2 seconds at full resolution.
• Power requirements: 240VAC @ 12VA, or 12VDC @ 900mA max.
• Cooling system: Regulated set-point cooling supply with thermoelectric cooler to give a minimum CCD temperature of approximately -40C below ambient.
• Size: 75 x 70mm black anodised aluminium barrel with 42mm ‘T2’ thread at the CCD window end & input/output plugs at rear. CCD alignment screws are provided for setting the chip parallel to the focal plane.
• Weight: approx. 450g.

PRODUCT MANUAL Trius-PRO-674C-handbook

PRODUCT DATASHEET 2022-SX-TRIUS-PRO-Blue-Camera-Specification

Overview

• Very large, high resolution ‘SuperHAD’ CCD chip, with 6,000,000 x 7.8uM square pixels in a 23.4 x 15.6mm array. Size equivalent to APS film.
• Single-shot colour, using a Bayer matrix of R, G and B on-chip filters. No filter wheel required.
• Triple USB hub for accessories, built-in.
• High performance two stage cooler for better than -35 C chip temperature reduction.
• Dry Argon chamber fill for improved cooling performance.
• Exceptionally low dark signal – No dark frames necessary for most deep sky objects.
• Exceptionally effective anti-blooming with minimal effect on linearity and no lost active area.
• High sensitivity, equivalent to 60% QE at peak of green filters.
• Back focal length 17mm +/-1mm.
• NEW! Built-in super high speed USB 2.0 interface (USB 1.1 compatible) for approx. 3.5 second downloads.
• Built-in autoguider output.
• Single USB cable control for all features – get rid of that dangerous cable tangle!
• Only ONE computer needed to control all of the devices and functions.
• Very low power consumption. Less than 1.5 amps at 12v DC.
• Compact and lightweight – only 75mm in diameter x 100mm long – less than 500 grams load on the ‘scope.

Specifications:

• CCD type: Sony ICX453AQ SuperHAD CCD with ultra low dark current, Bayer RGB matrix and vertical anti-blooming.
• CCD Full resolution Pixel data: Pixel size: 7.8uM x 7.8uM, Image format: 3024 x 2016 pixels
• CCD Image area: 23.4mm (Horizontal) x 15.6mm (Vertical).
• CCD quality: Grade 1 or better – No bad columns, no dead pixels, no more than 50 ‘hot’ pixels (saturated in <10 seconds).
• Spectral Response: QE max at 540nM (~60%), 50% roll-off at 400nM and 650nM.
• Readout Noise: Less than 12 electrons RMS – typically ONLY 7 electrons!
• Full-well capacity: Greater than 25,000 e- (unbinned)
• Anti-blooming: Overload margin greater than 800x.
• Dark current: Dark frame saturation time greater than 100 hours. Less than 0.02 electrons/second @ + 10C ambient.
• Data format: 16 bits.
• System gain: 0.4 electrons per ADU
• Computer Interface: Built-in USB 2.0 compatible interface. Also works with USB 1.1.
• Image download time: Typically 3.5 seconds full resolution using USB 2.0, approximately 8 seconds with USB 1.1.
• Power requirements: 115VAC / 240VAC @ 12VA, or 12VDC @ 1.5 A max.
• Cooling system: Regulated constant current cooling supply with two stage thermoelectric cooler to give a CCD temperature of approximately -35C below ambient.
• Size: 75 x 70mm black anodised aluminium barrel with 42mm ‘T2’ thread at the CCD window end & input/output plugs at rear. CCD alignment screws are provided for setting the chip parallel to the focal plane.
• Weight: approx. 400g